Page 1 of 1
Need codes for Channel Master programmable rotator remote
Posted: Wed Apr 21, 2004 3:06 pm
by tiger1218
I need the codes for a 9521a Channel Master programmable rotator controller with infra-red remote control. I checked the yahoo files and did not find anything.
Thanks, Mike
Posted: Wed Apr 21, 2004 3:23 pm
by Mark Pierson
Have you read this
thread yet?
Posted: Wed Apr 21, 2004 9:47 pm
by Glenn
Tiger,
Check the Yahoo files again under misc I just added a file that worked for me with URC-6131 and URC-8810w. I'll also try to link it here, but I have never done it before and I'm not sure I'll do it correctly.
Give this a try
click here
Good Luck,
Glenn
Thanks
Posted: Thu Apr 22, 2004 12:07 pm
by tiger1218
Thanks for the replies. I have multiple ways of dealing with this now.