JP1 Remotes

Hy
i cant sinc my urc 3910 with the projector (pa1000) with the codes given on manual.
is there a reason for that ,and can i get around it ,ty.

To help others help you, based on your previous thread, I have completed the template for you

1. Device: LG PA1000
2. Type of device: projector
3. Year: current
4. JP1/UEI Remote model: URC-3910
5. Do you have a JP1 cable? no
6. Still have original remote? yes
7. Checked the file section? no LG projectors
8. Checked Pronto file section (at R/C)? no LG projectors
9. Partially working setup code? no
10. Learning remote question? n/a
11. Have you tried the JP1 Lookup Tool?

Looking at the user manual, I see that they list several setup codes for LG.

However, if you recall, Steve posted that he believes the LG uses NEC1, dev 4, sub-device 15, which would require an upgrade.

zaphod7501 wrote:Which projector is it? If it's the 1500 then it probably uses the same codes as the USA version and some other LG PJs. 00168 is probably the EFC for the "Quick Menu" (as it's called on the US versions) but the format is NEC1, device 4, subdevice 15, which may not be built in and you might require a device upgrade.

There are a number of discrete commands that will work that can be found in the LG master file that can be found in the file section. Danger! note there is a command called power-only that puts the set into a factory mode of some sort that may mess it up badly.

so how do i upgrade it,do i need a cable

Confirmed via Harmony it is NEC1 device 4.15, which is an unusual combination I am unable to find anywhere in UEI's codes including EZ-RC

Unfortunately this is not the same as NEC1 device 4, so yes it will require an upgrade.

I don't believe that remote is upgradeable by any means, someone can correct me if I'm wrong. Look at it and see if it has any connector in the battery compartment or elsewhere. Post a picture if so.

I will upload the upgrade for anyone who may need it for other remotes.

If it was me, I would solve the problem by buying a URC-6440.

I created an upgrade for this Nec1 4.15 Projector
https://www.hifi-remote.com/forums/dload ... e_id=13770

so how do i upgrade it,do i need a cable

If you want to control this projector with a universal remote, you will need a programmable remote control.

That would be any learning remote,
Or remote that can be programmed via computer.

I am unfamiliar with the URC3910, does it have a 6 pin connector?