Page 1 of 1
Nevo C2 "White Screen of Death"
Posted: Sun Oct 04, 2015 3:58 pm
by ncoig
Anyone experienced this?
The remote will update and be programmed thru the UEI website without issue, but the screen never deviates from full-on white pixels...
It too the firmware update from the site, but no change in behavior.
Unit is brand new (supposedly)
-N
Posted: Sun Oct 04, 2015 4:14 pm
by The Robman
did it work before or did it come like this?
if it used to work, can you recall what the last thing you did to it was, before this happened?
Posted: Sun Oct 04, 2015 5:52 pm
by mdavej
I had one like that. Got a refund.
Posted: Sat Oct 17, 2015 4:43 pm
by ncoig
The Robman wrote:did it work before or did it come like this?
if it used to work, can you recall what the last thing you did to it was, before this happened?
Showed up like that. :/
-N
Posted: Sat Oct 17, 2015 4:44 pm
by ncoig
mdavej wrote:I had one like that. Got a refund.
This joker wants me to pay to ship the two defects back to him in China. Least this guy could do it pop 3 AAs in the things before he sends them.
-N
Posted: Sat Oct 17, 2015 6:22 pm
by mdavej
Which seller? We can make sure he doesn't sell any more.
Posted: Sat Nov 21, 2015 2:22 pm
by Dimentey
If it does not go into download mode with the computer (firmware upgrade mode):
Hold down the Power and Ok, insert the battery, the remote control will go into USB mode. Connect cable and update from the site. (You may need a few times and with different laptops)