JP1 Remotes

I am using URC-6131 JP1 enabled, Apex TV and a Panasonic DVD changer/HT system. I "locked" the volume to the HT and the remote is on SAT device all the time. I set up a "Master Power" so it first turn the TV on and then the HT system.
My problem is that there is a slight delay from the time the TV is on until the HT systems turns on.
Is there a way to shorten or eliminate the delay between the two devices?
All I see in the Macro window in IR.exe is TV;RCVR.

Thanks for your help.

Using extenders generally speeds up macros.

Also, is the delay a result of startup time of the HT? Does it just take a long time to power up? Maybe you could reorder your "Master Power" macro to turn on the HT first?

No, it is not the internal delay of the HT (from the time it is turned on till it is actually "active"), what I am refering to is that there is a delay of about two seconds between the signal that is sent to the TV (and turns the TV on) and the next signal that is sent to the HT.
BTW - same on the OFF command as well - the TV is turned off, but I can still hear the TV broadcast through the HT for another 2 seconds.

Maybe there's something unique to the way the "Master Power" macro works. Have you tried using a "normal" macro, one actually create in IR?

No, I haven't done that yet.
But, I think I read somewhere (or maybe I was dreaming) about a way to change the timing of a macro...?!

Installing the extender will most definitely speed up your macros. This is the only way I know to make them go faster. There are a number of different ways to make macros run more slowly, but that isn't what you want.