JP1 Remotes

I downloaded my extended 1056B01 to IR, looked it over, then opened up a NON extended 1056B01 IR file that I know works on my other 1056b01. I didn't deactivate the extender before doing below.

Got the warning about sigs not matching and proceeded to load the non extended IR file. After this, my 1056 is totally dead. I guess I bricked it.

Is there any way to bring it back to life ?

Thanks for any info !

just put the extended file back in and all should be good


if not, PM me and I can help off line

Thanks for your reply. I can't do anything with it, the interface doesn't even detect it, it's as if it doesn't have any batteries in it, totally dead.

I'll PM you.

Thanks again,

Sam