JP1 Remotes

Is there any way to create a new code to change channel.
For example: If I want a button to change channel to 354, I would make a macro to enter 3, then 5, then 4.
Is there a code for the number 354, and would it work this way.
Hope this is not a far out question.
Thanks
Jack Relahan

What model remote are you using and are you using the extender?

The best way to accomplish something similar to what you described is using a "Device Specific Macro". Those are much simple with an extender than without.

Though maybe what you want is just a fav channel list feature working in a sensible way (as it does with some extenders) rather than the stupid way it is built-in on models that have that feature.

I have the RS15-2116 remote. I use the JP1 Connector with great results. I've tried the extender for the 2116 but I can't understand how to use it. I've read all the text files that come with the extender but can't make anything work. Had a hard time with just the JP1 connector when I first started and now do quite good with it. Will just have to keep working on the extender unless you have a magic trick up your sleeve for me.
Thanks again
Jack Relahan

JackRelahan wrote:Is there a code for the number 354, and would it work this way.

If you're asking if there's an EFC that you can program to do the "3-5-4" channel change, the answer is no. A macro is your only option.

I was hoping there was a way to add EFC's 3,5 and 4 together to make EFC for 354. Sure would make a faster button responce. Anyway, thanks for all your inputs. Back to the drawing board.
Jack R

The extender can transmit a macro or DSM much faster than the remote without an extender can transmit a macro. Maybe that will be too fast for the the device receiving the digits. If you don't need to slow it down for the device, I think you'll find it acceptable speed to feel like good button response.