Page 1 of 1
Posted: Tue Nov 29, 2011 1:57 am
by Feuerbard
Posted: Tue Nov 29, 2011 11:02 am
by eferz
Feuerbard wrote:i have one xsight touch suddenly dead - some pictures of hardware
I'm sorry for your loss. You have my condolences. Thank you for sharing these pictures with us.
That's really intense that the remote control is using an
ARM9E processor almost seems like overkill. My apologies for the choice or words.
Posted: Tue Nov 29, 2011 11:48 am
by vickyg2003
Are you sure its dead and not just in a coma? Have you tried new batteries and a manufacturers reset?
Posted: Tue Nov 29, 2011 11:59 am
by Feuerbard
Are you sure its dead and not just in a coma? Have you tried new batteries and a manufacturers reset?
all internal power supply ok (1.8v and 3.0v on arm cpu , akku ok = 4.18v, clicking noise from buzzer , on start current is 200 - 230 ma from external PSU on 4.2v
Posted: Fri Oct 12, 2012 5:17 am
by nothinghood
Same problem here.
I've ordered new battery on ebay but it didn't solve the problem.
Little later I noticed that if I put a strong light on the LCD I can see the "Xsight touch" boot screen, then nothing, then "Xsight touch" boot screen again in loop.
It seems that the remote boot and crash before the backlight step.
Maybe it's firmware related.
Additional info: in this state PC doesn't see remote when connected with USB cable.
Anyone knows how to perform some kind of reset? (I've already tried to remove batteries)
Button combination, hold button(s) and put battery back, etc?
Any help will be appreciated.
Posted: Thu Jan 03, 2013 5:27 am
by Feuerbard
Anyone knows how to perform some kind of reset? (I've already tried to remove batteries)
Button combination, hold button(s) and put battery back, etc?
try to press OK and Power without battrey and place battery keep pressing
in my case after this - i find strange results , place over charging contacts at bottom overheating (150 - 200 C) - i find 4 dead components - 1 IC , 2 transistors and one diod , after desolder them i see xsight logo without resets but no light
Posted: Thu Jan 03, 2013 7:29 am
by Feuerbard
finally - under strong light i see buttons on lcd . remote working but no lcd and button backlight and charging
Posted: Tue Nov 18, 2014 9:13 am
by dnick
nothinghood wrote:Same problem here.
I've ordered new battery on ebay but it didn't solve the problem.
Little later I noticed that if I put a strong light on the LCD I can see the "Xsight touch" boot screen, then nothing, then "Xsight touch" boot screen again in loop.
It seems that the remote boot and crash before the backlight step.
Maybe it's firmware related.
Additional info: in this state PC doesn't see remote when connected with USB cable.
Anyone knows how to perform some kind of reset? (I've already tried to remove batteries)
Button combination, hold button(s) and put battery back, etc?
Any help will be appreciated.
Same thing happened to mine. Anyone manage to get it working again?
Posted: Tue Nov 18, 2014 9:16 am
by xnappo
Posted: Tue Nov 18, 2014 9:42 am
by dnick
Thanks,
I just tried that procedure. Unfortunately it didn't help. I noticed that now boot logo no longer appears.
Posted: Tue Nov 18, 2014 11:19 am
by Feuerbard
i buy replacement board (remote with dead screen) for 15$ from this seller
http://www.ebay.com/usr/allshop29?_trks ... 1543.l2754
