Page 1 of 1
Can device keys send a command
Posted: Sat Jan 31, 2004 1:44 pm
by eddie_bowers
I have been albe to use the software to make just about any button do what I want, but I can't get the device keys (TV SAT DVD etc...) to send a command as well as swtich the modes of the remote.
I have the URC-8811. Can this be done. IR.Exe appears to let you do this, but can you really do it?
On a side note, my other challenge is getting macros to work on those buttons if that can be done.
-Eddie
Posted: Sat Jan 31, 2004 2:05 pm
by The Robman
The remote is programmed to not let you do this, but if you use an extender you can get around those restrictions.
Posted: Sat Jan 31, 2004 5:14 pm
by eddie_bowers
OK, I heard of extenders, but nothing that I can find says what they are. What are they?
-Eddie
Posted: Sat Jan 31, 2004 5:20 pm
by The Robman
They are programs that you can load into your remote. They take over control of the remote and override all the built in restrictions. There is a folder for them over at Yahoo and there's a forum for questions on them here.
Posted: Sat Jan 31, 2004 5:23 pm
by Mark Pierson
An extender essentially "extends" the functionality of the remote. Typically, they eliminate some of the restrictions of the default remote (like macros on device buttons). In addition, they usually offer other features not found in the default remote. Some of these include the ToadTog special protocol, faster macro execution, nested macros, etc.
The extender for the 8811 happens to be one of the most powerful, and popular, extenders available.
Posted: Sun Feb 01, 2004 12:48 pm
by eddie_bowers
Sorry if this is a dumb question, but which one is for the 8811? (looking at the file on Yahoo now)
Is it the one for the 8800? So basically 88xx?
-Eddie
Posted: Sun Feb 01, 2004 12:51 pm
by eddie_bowers
Sorry, it WAS a dumb questinon
I found it. It's the URC-6012
-EddieB