JP1 Remotes

1. Device: Active 5
2. Type of device: tv amplified remote controlled directional antenna
3. Year:2008
4. JP1/UEI Remote model: RS 15-2117
5. Do you have a JP1 cable? Yes
6. Still have original remote? No
7. Checked the file section? Yes
8. Checked Pronto file section (at R/C)? Yes
9. Partially working setup code? no
10. Learning remote question? na

Manufactured by DX Antenna Co, Kobe Japan under several brand names

Have you tried the Channel Master Upgrade?

Older models of the DX Antennas used to use Cable/41 and Cable/65, both NEC1 118 types. Power = EFC.234 in both upgrades but the numeric buttons are quite different. 9 = efc.041 in Cable/41. 9 =efc.245 in Cable 65. Cable 41 has recently made a comeback in the JP1.2 remotes, so this might be worth a shot.

The box doesnt respond to the channelmaster Mod 9537 remote control- I will try your other suggestions Wednesday when I get home.

I was editing my post when you posted. I'm hoping to hear that you found a solution.

Give this a try CBL-0041

jwcldwll wrote:1. Device: Active 5
4. JP1/UEI Remote model: RS 15-2117
5. Do you have a JP1 cable? Yes

Manufactured by DX Antenna Co, Kobe Japan under several brand names

Found a match and recorded the IR signals with the JP1 tools to create the respective files.

• ICT file: http://www.hifi-remote.com/forums/dload ... e_id=10586
• RMDU file: http://www.hifi-remote.com/forums/dload ... e_id=10587

This one is a little odd because it seems to interleave RC5 signals in between F12 but only for two of the four available commands. I decided to create an RMDU file based on the F12 signals. If this doesn't work then we'll push this into the protocol decode forum with hopes that someone can create an executor for it.