JP1 Remotes

The JP1.4 remote discussion has been split here:
http://www.hifi-remote.com/forums/viewt ... p?t=103667

Hello friends, i have 3 OSN URC-625000-04R00/00R00, jp1.3 & jp1.4 remotes, unfortunately its not detectable in RMIR, also could not extract the Raw File whereas i have extracted the file from of 1.4 in the past, can anyone please guide me what can be the problem?.
I have tried with CH340 Interface also with FTDI232L Usb to TTL Adaptor.
In The RMIR it says No RDF matches signature starting 3211 for (JP1.3)
And No Remote found for (JP1.4).Pics are uploaded here
Thanks.
https://imgur.com/a/8d5yiCo

Let's start with the JP1.3 remote. If RMIR gets as far as saying No RDF matches signature starting 3211 then you should be able to do a raw download with RMIR. On RMIR select Remote > Raw download, then on the panel that opens, press Download. That should then display the raw dowload in hex. Press Save and accept the default filename, then post the raw download for me to see.

If the signature really does start 3211 then you have never used RMIR with that remote. As for the JP1.4 remote, No remotes found does not give me anything to go on. Try a 983 command to read the remote signature and let me know what that gives.

OK i have uploaded the raw download of jp 1.3, Please have a look.
http://www.hifi-remote.com/forums/dload ... e_id=26850

mathdon wrote:Try a 983 command to read the remote signature and let me know what that gives.

I assume what you mean to say is that i have to read the blinks in the Factory Setup Menu as explain in the pics.
https://imgur.com/a/FJhZuzy

if i press TV+OK the remote blinks twice and goes into code settings menu
then i press 983 it Again Blinks twice.
But this blinking twice is only working in TV+OK.
Press OSN+OK (Blinks Twice)=Press 983 (Blink Only Once)

Tiku.

I think what Graham meant for you to do is to read the signature of the remote by entering 983 then push 1 and count the number of blinks then press 2 and count the blinks then 3 and 4
The 4 digits will be the signature of the remote
The 9xx commands are here
http://hifi-remote.com/wiki/index.php?t ... x_Commands

Randy is right. You first do a long press of Setup until it gives two flashes, then follow his instructions. However, as this is a JP1.4 remote, you have to press 1 through 5, not 4, to get a 5-digit signature.

Tiku, I see from the raw download that you posted that you are using RMIR v2.12.8. Please update it to the current version, RMIR v3.0.12.