JP1 Remotes

Split from here:
http://www.hifi-remote.com/forums/viewt ... p?t=103282

Tanzbaerli wrote:I just learned the basic necessary commands at first (EPSON EH-TW9400 is not supported out of the box) and planned to add other commands after a while when really needed for common use. So i run into this problem.

What protocol/device codes does your EPSON EH-TW9400 projector use? (In other words, when you look at the learned signals, do they show a protocol and device codes?). If they show NEC2 with device code 131, sub-device code 85, then it uses the same codeset as most other Epson projectors.

http://www.hifi-remote.com/forums/dload ... e_id=26728

If it's not NEC2 131.85, please post your RMIR file and we'll make an upgrade file for you.

The Robman wrote:http://www.hifi-remote.com/forums/dload ... e_id=26728

Thank you, the file works very good for all i need for my EPSON EH-TW9400!