JP1 Remotes

Posted: **Wed Oct 06, 2021 5:03 pm**

I have a Inteset 422-2 remote and a JP1 cable. I have installed the Common JP1.3 extender version 3.05 into a rmir file and uploaded it into the remote. The readme instructions say the following about activation:

Code: Select all

The keymove to activate is on the TV/OK key (not visible to RMIR).  To activate, press the TV/OK key after initial upload to the remote.  When the extender is activated, the device button will flash 4 times to  indicate activation.  Until deactivated, the extender will remain active.

I'm not sure what the TV/OK button is that the instructions refer to is, but this remote has a setup button, and I have tried long pressing that and I do not get the 4 flashes of the light, I also tried the big center ok button, and the button "B" button I am using for TV. The setup button long press yields 2 flashes and the other buttons just flash the normal once for a key press.

I feel like I'm missing something obvious here?

Posted: **Wed Oct 06, 2021 5:43 pm**

Device mode: TV
Button: OK (in the middle of the 4 arrow buttons)

Posted: **Sun Oct 10, 2021 1:33 pm**

For others with this Inteset 422-2: On this remote there are no hard labeled devices, instead there are A, B, C, and D. To activate the extender Press device A, then long press OK.

JP1 Remotes

Inteset 422-2 activate extender

Inteset 422-2 activate extender