Page 3 of 3
Posted: Tue Jul 29, 2008 4:41 pm
by The Robman
I have just created an IR file with all three upgrades pre-loaded and assigned to device buttons, so all you have to do is load the IR file into your remote and press a device button to test them.
Here's the file...
https://www.hifi-remote.com/forums/dload ... le_id=5683
Press CBL to test code 1, press DVD to test code 2 and press TV to test code 3.
Code 3 worked!!!!!!!!
Posted: Tue Jul 29, 2008 5:26 pm
by turk
Code 1 and 2 controlled the address 1 receiver but code 3 worked for the address 2 unit. Thanks Rob..Which update did you use to create this update?
Posted: Tue Jul 29, 2008 5:53 pm
by MaskedMan
when programming cbl/sat key, press the down cursor to change from cbl to sat, and then try code 2001.
Re: Code 3 worked!!!!!!!!
Posted: Tue Jul 29, 2008 8:06 pm
by The Robman
turk wrote:Code 1 and 2 controlled the address 1 receiver but code 3 worked for the address 2 unit. Thanks Rob..Which update did you use to create this update?
This one, but read my earlier post about how to use it.
https://www.hifi-remote.com/forums/dload ... le_id=1045
Thanks Rob for all your help
Posted: Tue Jul 29, 2008 9:04 pm
by turk
I had tried that earlier but not with unit code 3. Not sure why 3 is required but it works.