Page 2 of 2
Posted: Mon Jan 21, 2008 5:59 pm
by tfischer
Mark Pierson wrote:all you need to do is create the keymoves in IR's Key Moves tab bound to the TV device and the button of your choice, then specify TV/1001 as the Device Type and Setup Code, and enter the EFC/Hex Cmd. TV/1001 does not need to be assigned to any device button on the General tab, it just needs to be loaded in the remote.
I guess my question/confusion is in IR, under KeyMovers, what do I put for "device button" if the 'dummy' device isn't actually assigned to a device button at all?
Thanks again for all the help.
-Tim
Posted: Mon Jan 21, 2008 6:43 pm
by Mark Pierson
tfischer wrote:I guess my question/confusion is in IR, under KeyMovers, what do I put for "device button" if the 'dummy' device isn't actually assigned to a device button at all?
If you're referring to the section in the center of the dialog labeled Function to Perform, you ignore the table of of devices (that should mimic what's assigned on the General tab) and enter directly in the Device Type and Setup Code controls.
Posted: Mon Jan 21, 2008 8:36 pm
by tfischer
Worked like a charm! Thanks much... I'll probably be back with more questions in another thread but this issue appears to be solved!
-Tim