Page 2 of 2
Posted: Tue Mar 23, 2010 12:49 pm
by seb_131
Thanks for your help. I will try using unused button.
Posted: Tue Mar 23, 2010 7:01 pm
by vickyg2003
SEB, I may have misled you when I said that LKP's were not available to you. Check your user manual. Apparently some of the newer remotes do have LKP's built in.
Posted: Fri Mar 26, 2010 4:14 pm
by seb_131
Hi,
the remote was provided with my old Dreambox7000 few years ago. I have no dedicated user manual for it and it is quite old (but the remote works fine for my dm800 and can be re-programmed).
I ve also checked in the file section, but I think that nobody have created an extension.
I tryed also to program simple macros using an unsed button (with switch one), just by adding sequences of button action, but when I add Denon swithc on/off action, it fails and I have to reset my remote by removing battery. May be I am doing it wrong, or perhaps it is not possible to switch all may devices at the same time.
https://www.hifi-remote.com/forums/dload ... le_id=8211
See you.
Seb
Posted: Sat Mar 27, 2010 1:16 am
by seb_131
The problem come from the macro management.
I am able to create simple macro with only one function, but I can't peform sequence of function.
For example, if I create a simple macro with just TV;AUX the remote bugs when I execute it (no answer and I have to remove battery to reset it).
Any idea concerning this issue ?
Thanks
Regards
Seb
Resolved !
Ok, I ve done it. I need to insert a delay between each command using SHIFT(Setup) which has 1 sec pause.
See U