DMTECH TV/DVD Combo

Rod · Post by **Rod** » Fri Sep 12, 2008 9:55 pm

Looking for code to operate my New TV.

1. Device: DMTECH
2. Type of device: TV/DVD Combo
3. Year:07
4. JP1/UEI Remote model: 8910
5. Do you have a JP1 cable? yes
6. Still have original remote? yes
7. Checked the file section? yes
8. Checked Pronto file section (at R/C)? yes
9. Partially working setup code? no
10. Learning remote question? N/A

MaskedMan · Post by **MaskedMan** » Fri Sep 12, 2008 11:23 pm

Give dvd codes 0695 & 0821 a try.

Capn Trips · Post by **Capn Trips** » Sat Sep 13, 2008 4:49 am

You have all of the tools to do it yourself:
Original remote + Learning JP1 remote + cable.
Depending on your level of JP1-ing experience, it should take you between 30 minutes and a couple hours to learn, decode, and build your own upgrade for uploading back into the remote.

Check out the Beginners' Read Me sticky post (see link in my sig below)

Post by **The Robman** » Sat Sep 13, 2008 10:25 am

Rod wrote:10. Learning remote question? N/A

Why do you say the learning remote question is not applicable?

Rod · Post by **Rod** » Sun Sep 14, 2008 3:31 pm

I did it my self as was suggested. Who would imagine it would be so easy. By easy I mean 3hrs but now I know and will be much quicker next time.

Thanks guys.

Post by **The Robman** » Sun Sep 14, 2008 4:41 pm

Could you load your upgrade file into the file section please.

There are several tricks that speed up the process. For starters, if you go to the File > Summary sheet in IR.exe there's a section that lists the relevant codes for all the learned buttons. It's pretty easy to cut & paste this into a spreadsheet and then cut and paste the relevant columns over to KM.

It shouldn't take you more than 30 mins from start to finish to create an upgrade by learning all the buttons.

JP1 Remotes

DMTECH TV/DVD Combo

DMTECH TV/DVD Combo

Re: DMTECH TV/DVD Combo

Thanks for the help