Problems using KM to upgrade 9800 with dishnetwork 301 upgra

Post by **The Robman** » Tue Jul 29, 2008 4:41 pm

I have just created an IR file with all three upgrades pre-loaded and assigned to device buttons, so all you have to do is load the IR file into your remote and press a device button to test them.

Here's the file...
https://www.hifi-remote.com/forums/dload ... le_id=5683

Press CBL to test code 1, press DVD to test code 2 and press TV to test code 3.

turk · Post by **turk** » Tue Jul 29, 2008 5:26 pm

Code 1 and 2 controlled the address 1 receiver but code 3 worked for the address 2 unit. Thanks Rob..Which update did you use to create this update?

MaskedMan · Post by **MaskedMan** » Tue Jul 29, 2008 5:53 pm

when programming cbl/sat key, press the down cursor to change from cbl to sat, and then try code 2001.

Post by **The Robman** » Tue Jul 29, 2008 8:06 pm

turk wrote:Code 1 and 2 controlled the address 1 receiver but code 3 worked for the address 2 unit. Thanks Rob..Which update did you use to create this update?

This one, but read my earlier post about how to use it.

https://www.hifi-remote.com/forums/dload ... le_id=1045

turk · Post by **turk** » Tue Jul 29, 2008 9:04 pm

I had tried that earlier but not with unit code 3. Not sure why 3 is required but it works.

JP1 Remotes

Problems using KM to upgrade 9800 with dishnetwork 301 upgra

Code 3 worked!!!!!!!!

Re: Code 3 worked!!!!!!!!

Thanks Rob for all your help