RCA RV-9900 a/v receiver
Moderator: Moderators
-
kolabear999
- Posts: 1
- Joined: Fri Feb 02, 2007 6:36 am
RCA RV-9900 a/v receiver
unit is 8-10 years old. no problems, got up this morning - power is off to unit. will not power on. IT guy here at work told me to unplug it for a day. I really like this unit, any suggestions?
-
The Robman
- Site Owner
- Posts: 22023
- Joined: Fri Aug 01, 2003 9:37 am
- Location: Chicago, IL
- Contact:
Just FYI, I Googled this and it appears that the brand is RCA. (I edited the subject line to reflect this).
Last edited by The Robman on Fri Feb 02, 2007 8:59 am, edited 1 time in total.
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!
-
zaphod7501
- Posts: 539
- Joined: Mon Aug 02, 2004 7:07 pm
- Location: Peoria Illinois
After you plug it back in, pay close attention to the sequence of events. (clicks, display flashes, etc) Many of these units were designed without speaker relays so they don't have a conventional "Protect" mode when outputs fail.
If it clicks then goes dead, try disconnecting all speaker leads from the back and try again (unplug, wait 5 minutes, plug in, try again). If it comes on then you may have a speaker or wiring problem.
Completely dead (no clicks, flashes, etc) then it's going to need service. The only fuse you would even think about replacing is the AC line input fuse (not the DC supply fuses). If you can't determine which is which, then don't replace any, since replacing the DC fuses and powering "On" will do additional damage if the outputs are shorted.
If it clicks then goes dead, try disconnecting all speaker leads from the back and try again (unplug, wait 5 minutes, plug in, try again). If it comes on then you may have a speaker or wiring problem.
Completely dead (no clicks, flashes, etc) then it's going to need service. The only fuse you would even think about replacing is the AC line input fuse (not the DC supply fuses). If you can't determine which is which, then don't replace any, since replacing the DC fuses and powering "On" will do additional damage if the outputs are shorted.
Just call me Zaphod (or Steve) --- I never should have started using numbers in a screen name but I just can't stop now.