JP1 Remotes

[garytjia]

I just purchased a radio shack 15-2137 universal remote and had it setup to work with Marantz SR7200 receiver. However, it does not have the component type input switch available (e.g. DVD, CD, DSS, etc.) to allow switching between different components for sound output. I am still learning how to program the remote. Does anyone know how I could program the remote to include the input switch function?

This is a continuation of this thread...
http://www.remotecentral.com/cgi-bin/mboard/rc-one4all/thread.cgi?5159

Thanks

[kupakai]

Welcome to this forum. Did you get the DVR functions (from your post in remotecentral.com) to work? I should have asked you first which device code you have set for the that, and if you have tried all of them.

As for the receiver, I'll ask the same question; what device code did you set it on, and did you try all of the listed ones?

[garytjia]

No, I have not tried all the listed device codes for Marantz receivers...I will try them out. Thanks.

[irs009]

From what I've seen on these forums, and my own experience, the inputs often are found on the number keys. As you try all of the setup codes, be sure and check those for your inputs.

Jack

[Capn Trips]

It would be easier to provide you with detailed recommendations if you would use the mandatory template in the "Number 1 Code Search FAQ", linked in my sig below. Not knowing what setup code you are using makes it a bit harder to do so.

This file is an upgrade for your exact receiver. It has discrete input commmands. This upgrade uses the RC-5/5X combo protocol, used by built-in setup codes AUDIO/1089 and 1189, but the device codes are not identical.

It's also possible to generate about 2/3 of your device's signals using the RC-5 protocol, used in AUDIO/0189 (or possibly 0222 or 0269). I'm not sure whether the setup code you are using will support adding those commands via advanced code (EFC). If you're using AUDIO/1089 or 1189, here is the list of 5-digit EFCs: