Trouble with old Teac receiver

csaylor · Post by **csaylor** » Mon Dec 15, 2003 10:27 pm

Hello all, I am hoping you can help me with a problematic reciever I have.

I currently have a Teac AG-V1020 receiver. I am using it until I can replace it, but that will probably be several months away.

I have several remotes:

Millennium 4 B01
OFA 6131 Modified
RS 2116

Of the three, the Mill 4 is the only one that has a code that controls the receiver (0463). What I would like to do is either find a code for the 6131 and the 2116 or figure out how to transfer the codes from the Mill 4 to the other two.

I have been looking for information on how to do this myself and either I'm just not seeing it, or I'm not understanding what I am reading. If there is anybody out there that can point me in the right direction I would be extremely grateful.

Thank you

jamesgammel · Post by **jamesgammel** » Mon Dec 15, 2003 10:39 pm

Audio_0463, according to devices.xls is Nec1a protocol, devices 129 and 115. Rob may have the advance codes listed at his site. You could build an upgrade for the other two remotes with KM or RM and upload them. If you can't find a list, you can learn the signals from the Mill4 to the 2116, use IR to decode, and build from that. Strange that your receiver uses that one, it's the default audio code on the hidden fifth device of the Mill4. IF it isn't in the other two, apparantly it's been deleted from the native codes base of newer remotes.

Jim

jamesgammel · Post by **jamesgammel** » Mon Dec 15, 2003 11:08 pm

Advance codes list:
http://www.hifi-remote.com/cgi-bin2/ueic.cgi?amp_0463

Jim

csaylor · Post by **csaylor** » Tue Dec 16, 2003 5:28 pm

Thank you!

Merry Christmas