I have in the past successfully modified a 6011 remote by adding the jp1 connector and eeprom. I just tried to do the same mod to a 6131 remote, actually 2 and cannot get them to upload. I can get them to download to IR just fine but upload it gives me an error "data read differs from data written". I thought I might have messed up on the one remote so tried the second and the same problem. Any ideas?
I have been using this jp1 cable to my other remotes and it works fine.
robert
trouble uploading to 6131 remote
Moderator: Moderators
-
rduchynski
- Posts: 8
- Joined: Tue May 30, 2006 11:08 pm
I did get it to intermittantly upload. As far as I can tell it has a problem if I leave the batteries in when I connect it to the jp1 cable/computer. If I connect it without the batteries in it works fine. If I do start getting the upload error if I do a 981 reset and retry it works. Any ideas as to what is going on? I checked all my solder jts and they are good. This behavior is reproducable on both remotes.
robert
robert