Removing RF Puck from 9910

kcorth · Post by **kcorth** » Mon Nov 14, 2005 9:22 am

I have two 9910 remotes and want to remove the RF puck from one of them. I obviously want to do this without affecting the operation of the remote other than to disable the RF ability. Anyone know how to do this?

Thanks
Kevin

Post by **The Robman** » Mon Nov 14, 2005 9:35 am

There are 4 pins that connect the puck to the PCB, you would need to de-solder these. There's also 1 or 2 plastic poles that support the puck. These are sometimes hot-glued to the PCB, so you would need to un-glue these poles.

What do you intend to do with the puck once it's removed?

underquark · Post by **underquark** » Mon Nov 14, 2005 5:14 pm

Do you actually want to remove the puck (for use elesewhere??) or just disable its RF output? If the latter then you can surely disable it in situ.

kcorth · Post by **kcorth** » Tue Nov 15, 2005 9:15 am

I really just want the output disabled, but removing the puck altogether would be fine. I have no plans for using it once removed.

Thanks
Kevin