Fujitsu doesn't quite work as we discussed (in
this thread). If you leave subdevice blank in both the setup sheet and the functions sheet it is defaulting to zero, rather than to device. No subdevice is the common case. So as I said before, if the double defaulting is too hard, I'd rather leave subdevice off the setup sheet. (Of course I appreciate the fact that you added Fujitsu so quickly after it was discussed. So please don't take this as a complaint.)
I also rediscovered a problem that I thought you fixed a few versions ago. Everytime I switch to the functions sheet it resizes most of the columns to widths that are too small to display the column header. So I get lots of columns named "..."
When we first had this problem it wouldn't even let me adjust them to see the headers. No I can adjust them, but it forgets every time you switch tabs.
I think column widths should be remembered across tab switches and it would also be nice if default column widths were enough to display all the headers (subject to everything else fitting of course).