Somewhere I saw a post (and cannot find it now) where there was a way to modify the RDF file so a description could be put in for the device protocol code so in keymoves and general you might see "Sony TiVo" vs. 2001.
Am I making this up??? I have searched on the JPI and yahoo forums to no avail...
Thanks ahead...
greg
Commenting in IR.exe
Moderator: Moderators
-
Greg Williams
- Posts: 8
- Joined: Sun Oct 26, 2003 1:18 pm
- Location: Mid Georgia
-
Mark Pierson
- Expert
- Posts: 3017
- Joined: Sun Aug 03, 2003 12:13 am
- Location: Connecticut, USA
- Contact:
Under the "[DeviceButtons]" section of the appropriate RDF file, I usually
change the db-0x to match the special protocols that are bound to them
like db-dsm, db-ldkp, etc., so I can remember them easier than
misc/1103 and misc/1106.
In my experience, in the same section, you can rename TV to SonyTV
and IR would display SonyTV in the UI. I don't know if that is answering
what you are asking.
change the db-0x to match the special protocols that are bound to them
like db-dsm, db-ldkp, etc., so I can remember them easier than
misc/1103 and misc/1106.
In my experience, in the same section, you can rename TV to SonyTV
and IR would display SonyTV in the UI. I don't know if that is answering
what you are asking.