How do I know if I plugged correctly on RS 15-2133?

stephenw4 · Post by **stephenw4** » Mon May 23, 2005 8:13 pm

Hello folks, I recently got RS 15-2133 remote and JP1 kit though eBay today and I modified the remote so I could use JP1 cable to fit in so anyway, everything looks fine and I am concerned about which way I should plug the 6 pins connector on the cable because the remote does not have pin 1 marking on it just the holes for 6 pins connector and I've already installed it successfully so I do not want to risk damaging the remote if I plugged in wrong way, Can you able to tell me how I insert the cable's end in proper way -- if I plugged in wrong way, will it damage the remote or printer port?

Let me know and I'm looking forward to try out the software

gfb107 · Post by **gfb107** » Mon May 23, 2005 8:37 pm

You will not damage anything by plugging it in the wrong way.

stephenw4 · Post by **stephenw4** » Mon May 23, 2005 9:17 pm

Ok, thanks alot!! I asked you how do I know that I am able to communicate without any problems like running IR.EXE and use diagnostic tools to test the link to make sure it is communicating correctly?

Thanks!

Jeff_Birt · Post by **Jeff_Birt** » Mon May 23, 2005 10:39 pm

In IR click on 'Interface' and then 'Check Interface'. This will check for proper communication with the remote.