Hello! It’s been a while since I was last here. So firstly, I’d like to say that the software is even better than I remembered and the support that I and others have been given in the forums is absolutely phenomenal. Thanks to all involved!
I had a strange issue when setting up my URC-6440 (extension installed). When I selected PVR as the device, it didn’t control my PVR but did send some signals to my TV. It took me quite a while to figure out (especially as I thought it was something to do with the Activities/Combo button), so I thought it best to post in case anyone else encounters it. I was using RMIR version 3.2.15.
Here’s what I did: I reset my URC-6440 and then tried to upload a couple of Device Upgrades I created (one for a Toshiba TV, the second for a Humax FOXSAT HRD). Both upgrades use the NEC1 protocol but have different device codes (64, 191 for the TV and 0, 16 for the Humax). On the Devices tab, I create a new device and then open an existing Device Upgrade file (in this case for the TV), click OK the Device Upgrade editor and I am prompted for which button to assign the device to (I selected TV). I then repeat for the HUMAX and selected PVR. However, when I view the Device Code, both have 64, 191 (i.e. the TV). If I try the PVR first then the Device Codes are both 0, 16. Did I do something incorrectly, or is this a bug?
It doesn’t happen on URC-3661(which I created the Device Upgrades with) but I’ve also randomly tried URC-6820 and URC-7980 in RMIR and they show the same issue.
The workaround is to simply edit the Device Codes back to the correct ones, once the Device Upgrades have been added.
Jono
Issue with Device Upgrades using the same protocol
Moderator: Moderators