| View previous topic :: View next topic |
| Did anyone else see these? |
| Yes |
|
33% |
[ 1 ] |
| No |
|
66% |
[ 2 ] |
|
| Total Votes : 3 |
|
| Author |
Message |
120240VAC60HZ
Joined: 17 Mar 2007
Posts: 191
Location: Trumbull, Connecticut
|
 Posted: Sat Mar 29, 2025 4:31 pm Post subject: Anyone know anything about these "Anderic RRU401.6" |
 |
|
Does anyone know anything about these Anderic RRU401.6 remotes?
They appear to be an Inteset clone or some other Inteset derivative
Here is the manual they don't have any setup button and use four digit advanced programming commands so I am doubtful if these are of any use to the JP1 community?
They appear to have the opening for the 6-Pin connector whether or not it actually has header pins soldered is another story
I don't have or intend to buy one but I was just wondering if anyone else saw these and also had their interest peaked? Like they did for me
Thanks |
|
| Back to top |
|
 |
Barf
Expert
Joined: 24 Oct 2008
Posts: 1518
Location: Munich, Germany
|
| Posted: Mon Mar 31, 2025 12:05 pm Post subject: |
|
|
No, I have not heard about it before. Reading the description, they appear to be at least 20 years to late.
Ethernet? Bluetooth? RF? PC-configuration? Open-source hard/software? Voice-support? etc, etc.
And it looks like a Soviet tractor 
Is this serious? |
|
| Back to top |
|
|
MaskedMan
Tivo Expert
Joined: 10 Feb 2004
Posts: 1052
Location: Boone, IA
|
| Posted: Mon Mar 31, 2025 2:40 pm Post subject: |
|
|
Yes, I have this remote, it doesn't have pins. And it doesn't accept advanced codes on the remote itself. It's a piece of junk. That screw is a pain in the neck.
https://quickshare.samsungcloud.com/rdwuP2jRd3SD
_________________
Edmund |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
File Section
Wiki
