Newbie with Nevo C3: all tabs empty after "download&

ThunderOwl · Post by **ThunderOwl** » Thu Jul 04, 2024 3:35 pm

Hello All! Just got Nevo C3 today, found out about JP1 today, and installed Java RMIR today

I think I have set registry changes as needed, RMIR says right on top bar "Nevo C3". But, when I press "download", progressbar is active, but after that - all tabs of RMIR are empty. Please, what did I miss, what I didn't do, or did wrong? Thank You!

FIXED - please see my last post in this thread. "Factory Reset" helped.

mdavej · Post by **mdavej** » Thu Jul 04, 2024 6:48 pm

There may be some clues in your rmaster.err file. But my initial guess is you have RMIR in a folder that is lacking write permissions. So move it to Documents or Downloads or something like that.

ThunderOwl · Post by **ThunderOwl** » Fri Jul 05, 2024 3:04 am

Thank You for answering! Folder is under My Documents, it is fine, thanks for the tip about logfile! I will show the end of it, looks like there is something weird going on when getting devices.xcf, hmm:
(P.S.: I did try to "Reset" remote)

36 region
37 sys
38
39
3a
3b ?"
3c ?????????ename
3d directv_rf
3e enabled
3f assistant
40 powerkeys
41 audioinputs
42 pictureinputs
43 hardkey
44 softkey
45 sendir
Parsing error in devices.xcf
Data parsing ended
File home.xcf: bxmlStart=0 xcfStart=4c

File system.xcf: bxmlStart=0 xcfStart=c0

File home.xcf: bxmlStart=0 xcfStart=4c

File system.xcf: bxmlStart=0 xcfStart=c0

0000: 7 != 3
RemoteMaster.windowClosing() entered

mdavej wrote:There may be some clues in your rmaster.err file. But my initial guess is you have RMIR in a folder that is lacking write permissions. So move it to Documents or Downloads or something like that.

mdavej · Post by **mdavej** » Fri Jul 05, 2024 6:37 am

Looks like issues with some device names. Can you change or delete the first few up to DirecTV on the remote itself and try again?

ThunderOwl · Post by **ThunderOwl** » Fri Jul 05, 2024 6:58 am

EDIT - I did now FACTORY RESET (Press "Reset", then type "981", then press "Factory Reset"), not the "usual reset", and now download from my remote happens normally! That's nice progress here

Have to say - good first impression from Community here, thank You guys!

mdavej · Post by **mdavej** » Fri Jul 05, 2024 2:15 pm

Glad you got it working. If you need any icons, check out this thread. I've made some recent updates.
https://www.hifi-remote.com/forums/viewtopic.php?t=16296