RMIR MultiMacro

MrMoody · Post by **MrMoody** » Wed Apr 27, 2022 3:10 pm

What needs to be done in order for the latest RMIR to show the MultiMacro button? In the RDF I've added segment $02 to the list and the [MultiMacros] section after [Buttons] but I must still be missing something.

Post by **mathdon** » Thu Apr 28, 2022 5:49 am

What remote are you talking about? Post your RDF for me to look at, as nothing further should be needed.

MrMoody · Post by **MrMoody** » Thu Apr 28, 2022 2:57 pm

This is the URC-7980. I'm pretty certain it won't work but I wanted to test my segmented remotes and see if any of them have undocumented/undiscovered support.

http://www.hifi-remote.com/forums/dload ... e_id=26547

HamburgerHelper1 · Post by **HamburgerHelper1** » Thu Apr 28, 2022 3:41 pm

I think Its the MacroSupport=3 line that's giving you problems

MrMoody · Post by **MrMoody** » Thu Apr 28, 2022 6:45 pm

Hmm, the 3660 has the same line in it.

Post by **mathdon** » Fri Apr 29, 2022 6:33 am

HamburgerHelper1 is correct that you should not have changed MacroSupport value from 2 to 3. Read the entry for MacroSupport in RDF4Spec_Addendum_rev21 in the Docs folder of your RMIR installation. Values 2 and 3 mean very different things, 3 applies to the URC-3660 but not to the URC-7980. Value 2 means that the remote supports Controlled Macros. The combination of Controlled Macros and MultiMacros is not supported in RMIR as we have not seen a remote that supports it. If you want to test MultiMacros in the URC-7980 then you need to turn Controlled Macros off, either by deleting the MacroSupport entry or setting it to 1.