oarc05g won't learn on select key

ckeays · Post by **ckeays** » Thu May 27, 2021 7:47 am

Hi Everyone.

I have a oarc05g learning remote. The remote successfully learned all commands in all modes except TV mode. In TV mode it will not learn commands for keys, 0, LAST, MUTE, and OK/ENTER.

So I thought I would try the direct code entry. I found the TV code for my TV, however the OK/Enter command is wrong. All other commands are correct.

Since the remote is a learning remote, I tried to force it to learn the OK/Enter command from the original remote. This has failed every time.

I tried the obvious, new batteries, operational reset (980), and still nothing.
The OK/Enter key will successfully learn any code in all other modes except TV mode.

The TV code is 10000 for a Sony TV. (It's actually an RCA TV, but uses Sony12 protocol)

Just curious if anyone has this issue?

Post by **The Robman** » Thu May 27, 2021 8:55 am

This is the remote that we decided wasn't compatible with JP1, right?

As per the below thread:
http://www.hifi-remote.com/forums/viewtopic.php?t=12482

ckeays · Post by **ckeays** » Thu May 27, 2021 9:51 am

Yes that's the one. 5 device One For ALL Learning Remote.

I did manage to get another remote (exactly the same) to work with the select key in TV mode.

weird, the remote is new. The OK/enter key and membrane are fine (it learns and works in all other modes)

I thought a reset would clear everything but it did not help.

ckeays · Post by **ckeays** » Mon May 31, 2021 5:49 am

After multiple operational resets (setup, 980), the select key now learns in TV mode.