URC-6440/OARUSB04G Extender 1.03 now available

Post by **mathdon** » Thu Aug 13, 2015 9:09 am

I have now posted version 1.04 of this extender, incorporating the new features discussed above. I have started this separate thread for announcement and discussion of this new version.

ncoig · Post by **ncoig** » Sat Sep 12, 2015 4:53 pm

Graham,

Am I correct in presuming if you have a LKP Macro on a device button that the inherent SHIFT-DEV2, XSHIFT-DEV3 functionality to select a device is broken? (at least on DEV3, since perhaps you can shift-cloak the first two DEVs...)

I have something on STB3, but LKPs on the device buttons, and a triple shift to STB doesn't get me to STB3.

-N

Post by **mathdon** » Sun Sep 13, 2015 7:16 am

ncoig wrote:Am I correct in presuming if you have a LKP Macro on a device button that the inherent SHIFT-DEV2, XSHIFT-DEV3 functionality to select a device is broken? (at least on DEV3, since perhaps you can shift-cloak the first two DEVs...)

If this is so, I am not aware of it. Please post a .rmir file that exhibits this behaviour for me to look at.

ncoig · Post by **ncoig** » Wed Sep 16, 2015 12:08 am

mathdon wrote:
ncoig wrote:Am I correct in presuming if you have a LKP Macro on a device button that the inherent SHIFT-DEV2, XSHIFT-DEV3 functionality to select a device is broken? (at least on DEV3, since perhaps you can shift-cloak the first two DEVs...)
If this is so, I am not aware of it. Please post a .rmir file that exhibits this behaviour for me to look at.

I think this must have been a complication of the non-working Roomba device upgrade, as I went to upload a file, and before doing so, I tested it and it worked correctly.

Crisis averted.

-N