anyone can help me get I-O data HVTR-BTL code

ykchiang · Post by **ykchiang** » Fri Mar 28, 2014 9:25 am

Hi Alan Richey,

It work very good on my slingbox except the switch key (switch BS/CS signal)does not supported.

Thank you very much.

alanrichey · Post by **alanrichey** » Fri Mar 28, 2014 11:39 am

Do you need them ? We could try an figure it out by trial and error. Long job though.

ykchiang · Post by **ykchiang** » Sun Mar 30, 2014 5:07 am

Hi

I do not often use this key, now
Thank you very much for your help

berainxda · Post by **berainxda** » Thu Jun 04, 2015 2:41 am

I have been successfully using the remote posted by alanrichey for the HVTR-BCTL posted at http://www.hifi-remote.com/forums/dload ... e_id=12431 for the past year. However there's always been one annoyance that's been extremely frustrating that I've been unable to address.

The issue is that the "return" button on the remote doesn't function. This is the button that allows you to go back one step in menus or revert back from the current screen. This is especially difficult when using the DVR function of the tuner. I've come up with some elaborate workarounds but makes things in general very difficult.

I'm finally back in Japan for a short time and have physical access to the Slingbox but have no idea how to address this.

Any pointers?

chuliu · Post by **chuliu** » Thu Jun 04, 2015 4:52 am

I checked the sginal from slingbox 500 by setting one of the inputs to hvtr-btl.
I determined that power off key is actually exit button.
You can use remotemaster to map power off function to exit button and that should work for you.

Thanks.

alanrichey · Post by **alanrichey** » Thu Jun 04, 2015 10:46 am

Done, and updated http://www.hifi-remote.com/forums/dload ... e_id=12431

Any good ?

berainxda · Post by **berainxda** » Thu Jun 04, 2015 6:10 pm

Thank you all for your help and such a rapid response. I have both good news and an apology to make.

As I was getting ready to test the new bin file I decided to see if there was any change to Slingbox's available remotes. I found the HVTR-BCTL listed as expected and decided to check to see if there was any difference in behavior from last year (essentially didn't function). On the contrary I found that the remote was functioning correctly including the "return" function.

I'm sorry to have posted this request without first trying this but I honestly didn't expect any change in behavior or updates on the Slingbox provided remotes. And given my limited time in the country I didn't really have much time to troubleshoot this.

Having been said I'm looking forward to the improved function of the remote. Thank you again for your help.

alanrichey · Post by **alanrichey** » Thu Jun 04, 2015 11:25 pm

No worries, only took me 3 minutes to make the change. Glad it's all sorted.

JP1 Remotes

anyone can help me get I-O data HVTR-BTL code

I-O Data HVTR-BCTL Remote

I-O Data HVTR-BCTL Remote Update