Hi friends, can anybody please upload the front and back pics of the home made JP1.2/3 Interface for serial Port, as i find schematics diifficult to understand.
Thanks
Need pics Of Simple JP1.2/3 Interface for a SerialPort
Moderator: Moderators
-
Ellen
- Posts: 103
- Joined: Sun Aug 03, 2003 5:18 pm
- Location: East of the Rock, West of the Hard Place
In looking thru my stuff, I found this old thread that I started on this very subject.
It doesn't have pictures but what it does is point to the older document for building a prior version of the JP1.x interface that includes Tommy's great construction guide. With it you should be able to build the interface as it shows you exactly where to place the components on a piece of perf board and where to connect them to each other on the back side. As you can see in that thread, it is what I used to construct my cable.
Important note from that thread is to cut the cable to pin 5.
All that said, I found my old cable and took a few pics. No wise cracks about my crappy soldering
It doesn't have pictures but what it does is point to the older document for building a prior version of the JP1.x interface that includes Tommy's great construction guide. With it you should be able to build the interface as it shows you exactly where to place the components on a piece of perf board and where to connect them to each other on the back side. As you can see in that thread, it is what I used to construct my cable.
Important note from that thread is to cut the cable to pin 5.
All that said, I found my old cable and took a few pics. No wise cracks about my crappy soldering
Last edited by Ellen on Fri Dec 04, 2020 9:21 am, edited 1 time in total.