I need remote for satellite Maspro DT400

hikaru7 · Post by **hikaru7** » Mon Jul 01, 2013 10:46 am

My slingbox is pro HD, hope someone can share remote bin of Maspro DT400.

alanrichey · Post by **alanrichey** » Tue Jul 02, 2013 4:39 am

Does the Maspro DT35 remote not work ?

hikaru7 · Post by **hikaru7** » Tue Jul 02, 2013 8:43 am

I didn't try it because I've found someone post that not workable.

Post by **vickyg2003** » Tue Jul 02, 2013 10:50 am

Alan, you had the Maspro DT330 in the archive section that uses a Mitsubishi device 71 protocol, while Eferz's DT35 uses Nec1 202.90.

I assume if its in the archive section, that means that the person requesting it never left feedback, and Eferz's attempt was "unconfirmed".

I didn't try it because I've found someone post that not workable.

Hikaru7, could you please try Alan's
Maspro DT330
https://www.hifi-remote.com/forums/dload ... le_id=9686

And
Efere'z Maspro DT35
https://www.hifi-remote.com/forums/dload ... le_id=8948

and let us know if either works.

hikaru7 · Post by **hikaru7** » Thu Jul 04, 2013 10:40 pm

I have tried both codes and make sure light bulb is ok through camera lens.
But unfortunately don't work at all.

I have remote controller+USB IrDA+PC
Is there any other way can solve this problem?

alanrichey · Post by **alanrichey** » Fri Jul 05, 2013 5:29 am

Try this one

https://www.hifi-remote.com/forums/dload ... e_id=11971

hikaru7 · Post by **hikaru7** » Fri Jul 05, 2013 9:02 am

I upload the C2010_PL.bin file by web setup, the remote pannel apears but buttons can not be pushed. same situation as another RV file.

I also try to upload bin by setup assistant, I put the file in SBAV folder. but shows "Custom remote code not found. Please try a different code".

It still not workable to me.

alanrichey · Post by **alanrichey** » Fri Jul 05, 2013 9:36 am

Sorry, my fault, I didn't build it properly. Try again with the new copy (same URL)

hikaru7 · Post by **hikaru7** » Fri Jul 05, 2013 10:28 am

Alan, great thanks to you. Power on/off is ok; channel up/down is ok; numeric pad is ok; Guide, Menu and Info buttons are ok.

I have no idea how you can do it, awesome!!

alanrichey · Post by **alanrichey** » Fri Jul 05, 2013 11:52 am

Good, glad it worked