UEI Titan atlas OCAP / URC-2056BC0-R

Seion · Post by **Seion** » Tue Sep 25, 2012 6:19 pm

actually download from remote says no RDFs matches signature 3119

3FG · Post by **3FG** » Tue Sep 25, 2012 8:15 pm

I'm not sure why a raw download would give all zeros, but the good news is that RMIR knows the signature (311902) of your remote. It had to be able to read the remote to get the signature.

So I guess that your installation doesn't have the needed RDF or perhaps the RDF directory isn't set. You can download the 2056 RDF and make sure that it is in the designated RDF directory.

Seion · Post by **Seion** » Thu Sep 27, 2012 5:06 pm

ok got it working some what. So I created the TV Device and deleted the rest of the devices. I programmed most of the buttons the problem is most of them even if I set the button to an Item try and use the STB button to do the command so like if I click TV then hit the up arrow key the STB(Cable) Blinks and it doesnt work. I can change the volumn punch through and stuff since it was also trying to use the STB Button but what about the rest of the buttons?

Seion · Post by **Seion** » Sun Sep 30, 2012 11:23 am

well I got it to work by moving the device to the AUX button instead of the TV Button, now it doesnt try and use the STB device for the up and down and left and right buttons.

3FG · Post by **3FG** » Sun Sep 30, 2012 11:32 am

Seion,
Check on the General tab. I suspect that Channel PunchThrough is set to Cable for the TV device. Set CPT to TV if you want all buttons to be sent to the TV when the remote is in the TV device mode. Most users of cable or satellite systems actually want the digit buttons and Ch+/- to be sent to the Cable device, and that is the default behavior.

Seion · Post by **Seion** » Sun Sep 30, 2012 2:17 pm

I tried to change the channel punch through to tv only, but that only works for the channel buttons. So even if I press up and down when on the tv button it auto tries to use the STB device. The only way I can fix this is by using the AUX button as my TV device and it works just fine.

Anthony_Patrick · Post by **Anthony_Patrick** » Wed Nov 14, 2012 1:48 pm

I have not been able to reproduce Seion's problem on my Titan 2056I. I use RMIR v2.02 Beta 1.5r and the RDF / MAP files referenced by 3FG earlier in this thread. My testing still shows that Volume punch through / Transport punch through / Channel punch through all work as expected.

BTW this remote does return all zeros when you download it unless the correct RDF is installed - this is documented in another thread.

Because not all the internal data structures for the Titan have been analyzed, I use the following technique for setting it up and loading upgrades:
1. Do a code "981" factory reset.
2. Download the remote using RMIR and
3. use the "factory default" downloaded image as a base for installing upgrades, macros, settings, etc. using RMIR / RM.
4. Upload the embellished image, again using RMIR.

This method preserves any data that is set by "factory reset" that the RDF / RMIR does not know about.

I have been loading the Titan with this technique since March 2012 and have experienced no operational problems at all.