Remote address multiple satellite rcvrs in one house

turk · Post by **turk** » Tue Sep 18, 2012 8:05 pm

The Dish receivers in this house have specific Remote addresses so that one doesn't interfere with the other. The URC9800 and URC9910 that I have don't seem to allow you to program a remote address. Is there a way to upgrade these units to allow this? Thanks

These are actually Bell/Expressvu receivers and I believe the normal device code is 775

Post by **The Robman** » Tue Sep 18, 2012 9:15 pm

If u have a JP1 cable, you can load upgrades with whatever unit code you like.

mdavej · Post by **mdavej** » Wed Sep 19, 2012 8:45 am

You can also upgrade the 9910 via WAV file. How did you get 775 into your remotes in the first place? That code isn't in either of them AFAIK.

In any case, just download THIS upgrade and change the Remote Address.

MaskedMan · Post by **MaskedMan** » Wed Sep 19, 2012 3:27 pm

mdavej wrote:How did you get 0775 into your remotes in the first place? That code isn't in either of them AFAIK..

Sure it is, its listed in the urc9800 manual under Echostar, expressvu, and jvc.