JP1 Remotes

The Dish receivers in this house have specific Remote addresses so that one doesn't interfere with the other. The URC9800 and URC9910 that I have don't seem to allow you to program a remote address. Is there a way to upgrade these units to allow this? Thanks

These are actually Bell/Expressvu ...

Thanks Rob. Got it apart by prying case.
Google search works fine, wasn't aware that word search had been discontinued

Need to open case to repair keypad. Removed 2 screws but what next? Case seems tight. Thanks for help.

Tried search function but it doesn't seem to work.

I had tried that earlier but not with unit code 3. Not sure why 3 is required but it works.

Code 1 and 2 controlled the address 1 receiver but code 3 worked for the address 2 unit. Thanks Rob..Which update did you use to create this update?

This unit is driving me nuts. I copied your posts to ir and uploaded to 9800 but the remote didn't seem to like the code 2001. It would give an error when I tried to set the code for the cbl key. Which dish upgrade did you use? I would give up if the learn keys didn't work properly

Please explain the data that is shown for learned signals. If I receive an OBC of 26 and HEX of 6A when learning on my 9910 from a remote set up for address 2 , will I need the same OBC code and Hex code output from my 9800?What needs to be in KM for this same key?

Checked output of channel + channel - keys that work. These were put on 9910 learning keyPIP and L2. Still confused about device and subdevice numbers. They are 0 and 1 as read on IR.
See Link deleted

After loading 1170 from mdavej to 9800 checked output of ch+ key push using 9910 learning keys and found OBC10, Hex29,EFC075.
I don't know where these are coming from but don't think they are correct

Tried that version . It loaded fine. Also loaded code 1170 to CBL/SAT key.
But it will not control receiver. I doublechecked and have RDF1.28 and IR7.13 ???????

Link deleted

Here is ir file with upgrade pasted. Got error when assigned to a key.
It seemed to load the file to the 9800 but the 1170 code did not control the receiver

How do I load this into IR. I don't have RM on this computer

Please develop upgrade for 9800 of code 1170
Link deleted

Have tried other addresses.
I do have a 9910 with code 1170 that was sent to me by UEI in a wavefile.
It works fine with a 301 with address 2. Can I convert the wav to something I can load into 9800?

Tried that it didn't work