JP1 Remotes

Please try RMIR v3.0.8 which is now in the RMIR Development Folder and report back. I believe this now fixes your remaining issues, but if it does not and you can describe what still does not work, I will try again.
Graham,
I hope that you had a nice holiday. I have downloaded the new 3.08 version ...

To summarise the update happens after the 2nd change of tab focus on all the fields I tried
I did not understand your original post. The Robman posted his interpretation of it and has confirmed that I have fixed that. Now I don't understand your latest post. I cannot find any behaviour that ...

Rob, many thanks for this explanation. I have fixed this behaviour in RMIR v3.0.7, see this post . I should be grateful if rh100605 could please test that this fix meets his needs.
Graham,
I have downloaded and tried the 3.07 version.
After loading a device in RMIR and double clicking on the ...

If I download my remote programmed using RMIR and then click devices then double click NEC1 protocol and immediately click update, then line FF05 changes from CF to C7 which breaks the protocol.
Thanks for pointing this out. It appears to be a bug in RMIR which I will look into, but in the ...

Thanks, this is good because it confirms that the first learn posted was just a bad learn, the signal doesn't normally look like that. And yeah, looking at this, I would totally assume this was just a normal NEC1 signal, I am surprised that your device doesn't respond to it. It will take some time ...

Can you post the RMIR file which contains the learns that you captured from the R2?

Please upload the file to the Diagnosis Area in the file section, then post a link to the file here.

Thanks for helping out. The RMIR File has been uploaded to the diagnosis area It contains one learned key for ...

The URC1240 uses an S3F80 processor. You speak of changing R28 back from C7 to CF, so presumably your edit changed it from CF to C7. R28 is PF0. Bits 2 and 3 of PF0 set the words to send in the command portion of the signal. You are changing this setting from 3 (all protocol's variable parameters ...

I am using a All for one URC1240 remote to control a Ruark R2 radio. I have the original remote which I learned from.

I have decoded the Hex commands and using RMIR have created a new device to control the radio using the NEC1 protocol.

It works fine on the later model (R2i) but not on the older ...