JP1 Remotes

Now I see where I went wrong, yes the terminology was throwing me.

In order to access OBC's in the range 64 - 127, you will need to add
100 to the device code entered.

Capn Trips wrote:
Bottom line #2: Use device number 127 instead of 27.

When it said device code or device number, I took it ...

I uploaded this file so others can benefit.

KeyMaster file for Delphi XM SkyFi2

http://www.hifi-remote.com/forums/dload ... le_id=3343

I read the protocol help worksheet - although I may have misunderstood it.

Here's what I did:

On the Functions sheet, since my learned OBC values are over 63, I added 100 to the values.
For example, in the OBC column, if the learned value was 076, I entered 176.
If the learned value was 125, I ...

I was unable to get OBC to work either, but I'll try again and upload the files.

Thanks for your help! Below are links to the requested files.

(a) your IR file with learned signals
http://bellsouthpwp.net/k/e/kesteele/learned.IR

(b) your KM (or RM) file that you created
http://bellsouthpwp.net/k/e/kesteele/km.txt

(c) your IR file that you created and doesn't work right
http ...

I built an upgrade, but it doesn't work at all. I probably did something wrong, so I'll rebuild and try again. I did assign it to a button.

The original remote uses RC5. I've been reading on this forum about some RC5 toggling issues, but do not completely understand the circumstances.

No, I haven't tried to build the upgrade. I'll try that and report back.

I have a RadioShack 15-2117 that I purchased and programmed using JP1 a few years ago. I recently purchased a Delphi SkyFi 2 satellite radio that I would like to add to my RadioShack remote.

I want to customize the buttons, so rather than download one of the pre-configured files, I would like the ...

Rob, you are "The Man"

You hit the nail on the head. My learning technique was wrong. I was tapping the buttons rather than holding them down.

Using the "tap" method, I was getting different protocols, different frequencies and differing "Sent Once When Key Is Pressed" panel results, even for the ...

Yes, the built in code works for most buttons, I'm just trying to better understand how it works.

If the same button on the Toshiba is learned to two different keys on the 15-2117, shouldn't the data in the "Sent Once When Key Is Pressed" box be consistent?

I am learning keys from my Toshiba TV remote control to my RS 15-2117 remote control. I am downloading the 15-2117 into IR600 RC1.

I learned the "Menu" key from my Toshiba remote to two different keys on the 15-2117, the "Menu" and "Select" keys.

I am analyzing the "Raw Data" section in IR600 RC1 ...