JP1 Remotes

In RMIR, Punchthrough settings are on the "General" tab. There are columns for Volume, Channel and Transport punchthrough. If these columns don't show up after you download your remote to RMIR, please post again. Please note that the tabs, and their contents, vary a lot from one remote to another ...

I know this is a silly question but have you tried the 9-7-7 factory reset, that is, if the remote even responds to button presses?

I too have a INT-422-3. Just got my JP1 cable and was able to upload/download without any problems. One thing that I found, luckily before I connected the cable, was ...

yaworski wrote:Please post your remote model and RMIR version.

...Done...see initial post.

I'm setting up my 1st remote with RMIR.
Just to see how this works I manually programmed everything on my remote (not using JP1). I did the device code, learning, button copy, punch through, and macros.
I then downloaded my remote to RMIR.
I can see everything that I assigned with the exception of ...

wtherrell - good luck with the recovery. I also have a INT-422-3 and just ordered a JP1.2/1.3 cable. I'm totally new to the world of JP1 so I'll be following your posts. Unfortunately I don't have any suggestions on how to fix your problem. A while back I asked Inteset about the JP1 port and this ...